Jeep Wrangler: Using SiriusXM Guardian™ / Family Drive Alerts — If Equipped
Description
Family Drive Alerts help promote safer driving and give you peace of mind when your loved ones are out on the road. You can set boundary limits, monitor driving speed, and pinpoint your vehicle’s location any time, any place. Use the Uconnect app to set alerts:
- Boundary Alert
Receive a notification the moment your vehicle is driven either out of or into a geographic boundary that you set.
- Curfew Alert
Receive a notification when your car is being driven outside of the curfew time.
- Speed Alert
Receive a notification whenever your car exceeds a speed limit you set.
- Valet Alert
Receive a notification if and when your vehicle is driven outside a quarter-mile radius of a valet drop-off zone.
Google Assistant — If Equipped
With the Google Assistant, you can get help and
keep tabs on your car. The Assistant is available
across your devices, including Android™ phones, iPhone® devices, or
voice-activated
speakers, like Google Home...
SmartWatch Integration — If Equipped
Description
SmartWatch Integration puts the Uconnect app
right on your Apple® Watch or Android™ Wear.
To get started, follow these steps:
Download the Uconnect app from the App
Store® or Google Play...
Other information:
Jeep Wrangler 2018-2026 Owners Manual: Cargo Carpet (Four Door Models)
Remove the grommets under the rear seat (one left and one right). Pull the carpet out to the rear and open the carpet split around the seat belt attachment. Under Rear Seat Carpet Split Rear Carpet Remove the carpet under the load floor and the side support and then pull the carpet out...
Jeep Wrangler 2018-2026 Owners Manual: Locating The Upper Tether Anchorages
Two-Door Models: There are tether strap anchorages behind each rear seating position located on the back of the seat, near the floor. Tether Strap Anchorages (Two-Door Models) Four-Door Models: There are tether strap anchorages behind each rear seating position located on the back of the seat...
Categories
- Manuals Home
- Jeep Wrangler Owners Manual
- Jeep Wrangler Service Manual
- Service 4WD Warning Light — If Equipped
- UCONNECT SETTINGS
- SiriusXM® Satellite Radio Mode — If Equipped
- New on site
- Most important about car
Erasing All The HomeLink® Channels
To erase the channels, follow this procedure:
Place the ignition switch into the ON/RUN position. Push and hold the two outside HomeLink® buttons (I and III) for up to 20 seconds, or until the HomeLink® indicator light flashes.NOTE:
Erasing all channels should only be performed when programming HomeLink® for the first time. Do not erase channels when programming additional buttons.
