Jeep Wrangler: STARTING THE ENGINE — DIESEL ENGINE (IF EQUIPPED) / Automatic Transmission

Start the engine with the transmission gear selector in the PARK (P) position. Apply the brake before shifting to any driving range.

    STARTING THE ENGINE — DIESEL ENGINE (IF EQUIPPED)

    Before starting your vehicle, adjust your seat, both inside and outside mirrors, and fasten your seat belts. The starter is allowed to crank for up to 30-second intervals...

    Extreme Cold Weather

    The engine block heater is a resistance heater installed in the water jacket of the engine. It requires a 110–115 Volt AC electrical outlet with a grounded, three-wire extension cord...

    Other information:

    Jeep Wrangler 2018-2026 Owners Manual: Connecting The Jumper Cables


    Connect the positive (+) end of the jumper cable to the remote positive (+) post of the discharged vehicle. Connect the opposite end of the positive (+) jumper cable to the positive (+) post of the booster battery. Connect the negative end (-) of the jumper cable to the negative (-) post of the booster battery...

    Jeep Wrangler 2018-2026 Owners Manual: Replacement Bulbs


    NOTE: See an authorized dealer for LED bulb replacement. NOTE: Lens fogging can occur under certain atmospheric conditions. This will usually clear as atmospheric conditions change to allow the condensation to change back into a vapor. Turning the lamps on will usually accelerate the clearing process...

    Categories

    Basic Voice Commands

    The basic Voice Commands below can be given at any point while using your Uconnect system. Push the VR button on the steering wheel. After the beep, say:

    “Cancel” to stop a current voice session. “Help” to hear a list of suggested Voice Commands. “Repeat” to listen to the system prompts again.

    read more

     
    Copyright © 2026 www.jewrangler.com