Jeep Wrangler: STEERING WHEEL / Tilt/Telescoping Steering Column

This feature allows you to tilt the steering column upward or downward. It also allows you to lengthen or shorten the steering column. The tilt/telescoping lever is located on the steering column.

Jeep Wrangler. Tilt/Telescoping Steering Column

Tilt/Telescoping Steering Column Lever

To unlock the steering column, push the control handle downward (toward the floor). To tilt the steering column, move the steering wheel upward or downward as desired. To lengthen or shorten the steering column, pull the steering wheel outward or push it inward as desired. To lock the steering column in position, push the control handle upward until fully engaged.

WARNING!

Do not adjust the steering column while driving. Adjusting the steering column while driving or driving with the steering column unlocked, could cause the driver to lose control of the vehicle. Failure to follow this warning may result in serious injury or death.

    STEERING WHEEL

    ..

    Heated Steering Wheel — If Equipped

    The steering wheel contains a heating element that helps warm your hands in cold weather. The heated steering wheel has only one temperature setting...

    Other information:

    Jeep Wrangler 2018-2026 Owners Manual: Trailer Sway Control (TSC)


    TSC uses sensors in the vehicle to recognize an excessively swaying trailer and will take the appropriate actions to attempt to stop the sway. NOTE: TSC cannot stop all trailers from swaying. Always use caution when towing a trailer and follow the trailer tongue weight recommendations...

    Jeep Wrangler 2018-2026 Owners Manual: Front Head Restraints


    To raise the head restraint, pull upward on the head restraint. To lower the head restraint, push the adjustment button located on the base of the head restraint, and push downward on the head restraint. The release button does not need to be pushed to adjust the head restraint...

    Categories

    Erasing All The HomeLink® Channels

    To erase the channels, follow this procedure:

    Place the ignition switch into the ON/RUN position. Push and hold the two outside HomeLink® buttons (I and III) for up to 20 seconds, or until the HomeLink® indicator light flashes.

    NOTE:

    Erasing all channels should only be performed when programming HomeLink® for the first time. Do not erase channels when programming additional buttons.

    read more

     
    Copyright © 2026 www.jewrangler.com