Jeep Wrangler Manuals
Jeep Wrangler 2018-2026 Owners Manual / STARTING AND OPERATING / NORMAL OPERATION — DIESEL ENGINE / Stopping The Engine

Jeep Wrangler: NORMAL OPERATION — DIESEL ENGINE / Stopping The Engine

After full load operation, idle the engine for a few minutes before shutting it down. This idle period will allow the lubricating oil and coolant to carry excess heat away from the turbocharger.

NOTE:

Refer to the following chart for proper engine shutdown.

Jeep Wrangler. Stopping The Engine

NOTE:

Under certain conditions the engine fan will run after the engine is turned off. These conditions are under high load and high temperature conditions.

    Engine Idling

    Avoid prolonged idling, long periods of idling may be harmful to your engine because combustion chamber temperatures can drop so low that the fuel may not burn completely...

    Cooling System Tips — Automatic Transmission

    To reduce the potential for engine and transmission overheating in high ambient temperature conditions, take the following actions: City Driving — When stopped, shift the transmission into NEUTRAL (N) and increase engine idle speed...

    Other information:

    Jeep Wrangler 2018-2026 Owners Manual: Connecting The Jumper Cables


    Connect the positive (+) end of the jumper cable to the remote positive (+) post of the discharged vehicle. Connect the opposite end of the positive (+) jumper cable to the positive (+) post of the booster battery. Connect the negative end (-) of the jumper cable to the negative (-) post of the booster battery...

    Jeep Wrangler 2018-2026 Owners Manual: Android Auto™ And Apple CarPlay® Automatic Bluetooth® Pairing


    After connecting to Android Auto™ or Apple CarPlay® for the first time and undergoing the setup procedure, the smartphone pairs to the Uconnect system via Bluetooth® without any setup required every time it is within range, if Bluetooth® is turned on...

    Categories

    Erasing All The HomeLink® Channels

    To erase the channels, follow this procedure:

    Place the ignition switch into the ON/RUN position. Push and hold the two outside HomeLink® buttons (I and III) for up to 20 seconds, or until the HomeLink® indicator light flashes.

    NOTE:

    Erasing all channels should only be performed when programming HomeLink® for the first time. Do not erase channels when programming additional buttons.

    read more

     
    Copyright © 2026 www.jewrangler.com