Jeep Wrangler 2018-2026 Owners Manual / SERVICING AND MAINTENANCE / VEHICLE MAINTENANCE / Engine Oil Filter

Jeep Wrangler: VEHICLE MAINTENANCE / Engine Oil Filter

The engine oil filter should be replaced with a new filter at every engine oil change.

Engine Oil Filter Selection

A full-flow type disposable oil filter should be used for replacement. The quality of replacement filters varies considerably. Only high quality Mopar® filters should be used.

Engine Oil

Engine Oil Selection — 2.0L Engine (If Equipped) For best performance and maximum protection under all types of operating conditions, the manufacturer only recommend engine oils that are API SP/GF-6A certified and meet the requirements of the manufacturer Material Standard MS-13340...

Engine Air Cleaner Filter

For the proper maintenance intervals NOTE: Be sure to follow the “Severe Duty Conditions” maintenance interval if applicable. WARNING! The air induction system (air cleaner, hoses, etc...

Other information:

Jeep Wrangler 2018-2026 Owners Manual: MAX A/C Button

Press and release the MAX A/C button on the touchscreen to change the current setting to the coldest output of air. The MAX A/C indicator illuminates when MAX A/C is on. Pressing the button again will cause the MAX A/C operation to exit. NOTE: The MAX A/C button is only available on the touchscreen...

Jeep Wrangler 2018-2026 Owners Manual: Turning FCW On Or Off

The FCW button is located in the Uconnect display in the control settings. To turn the FCW system on, press the forward collision button once. To turn the FCW system off, press the forward collision button once. NOTE: When the FCW is “on”, this allows the system to warn the driver of a possible collision with the vehicle in front...

Erasing All The HomeLink® Channels

To erase the channels, follow this procedure:

Place the ignition switch into the ON/RUN position. Push and hold the two outside HomeLink® buttons (I and III) for up to 20 seconds, or until the HomeLink® indicator light flashes.

NOTE:

Erasing all channels should only be performed when programming HomeLink® for the first time. Do not erase channels when programming additional buttons.